LenzGuard automotive headlight protection film application instructions

lenzguard

Application instructions

	Clean lens thoroughly. Ensure your hands are clean and dry. Take the LenzGuard from the pack. DO NOT REMOVE the backing paper.
	Allow at least 10 to 20mm all round and mark out an oversize shape of the lens. The backing paper side must be against the headlamp.
	Trim excess from the LenzGuard.
	Warm the LenzGuard with the car heater, hairdryer, etc until it is flexible.
	Fold the backing paper from one end of the LenzGuard by 20 to 30mm.
	Very carefully position the LenzGuard, and with moderate pressure, press the exposed end in place.
	Carefully remove the backing paper while pressing the LenzGuard film onto the headlamp. Move the pressure back and forth across the film to minimize the number of airbubbles. If alignments tabs (small peaks of glass) are present, press the LenzGuard as close as possible, cut away a small circle for the tabs and press LenzGuard into place.
	Press out any larger air bubbles towards the edges. It might help to use the airdryer to reheat the LenzGuard when this is done. With a sharp blade, trim the LenzGuard to the final shape. Trim at right angles to the lens for the best finish. Tip: mark the final shape with masking tape first so that it's easier to see where to trim. Do not wash the car for 48 hours to allow the adhesive to set.